![]() If a firmware password is enabled and you try to temporarily change the startup volume by holding down the Option key at startup, you must authenticate.  Start up from a Server Diagnostics EFI NetBoot image using the Xserve front panel  Temporarily change the startup volume by holding down the F1 or D key at startup If a firmware password is enabled, you can't: After you run Server Diagnostics EFI and restart, the Xserve starts up from its default startup volume. When you release the button, the Xserve starts up from the Server Diagnostics EFI NetBoot disk image. The lights in the bottom row should now be advancing right to left.īottom row of lights advances right to left.ĥ Press the system identifier button repeatedly until the lower-left light turns on.Ħ While the lower-left light is on, press and hold the system identifier button until all the lights in the top row are on. If both rows of lights blink once, disable the firmware password.ģ When you release the system identifier button, the lower-right light should turn on.Ĥ Press the system identifier button again. For information about disabling the firmware password, see the next section, "Disabling the Firmware Password. If the two rows of lights on the front panel blink once and the Xserve resumes its startup sequence, a firmware password is enabled and you need to disable the password. On/standby button System identifier button Continue holding down the system identifier button until the top row of lights blink in sequence. Every effort has been made to ensure that the information in this manual is accurate. Use of the "keyboard" Apple logo (Option-Shift-K) for commercial purposes without the prior written consent of Apple may constitute trademark infringement and unfair competition in violation of federal and state laws. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Apple.
0 Comments
Leave a Reply. |